Cavity Wall Insulation Andover
Cavity wall insulation for Andover homes with unfilled cavities
At Loft Insulation Specialists, we help Andover homeowners fill the cavity in their outside walls with cavity wall insulation. Through small holes we drill in the outside wall, we inject Superbead EPS, a bonded bead of expanded polystyrene. The cavity is the gap between the wall’s two leaves: an outer one, usually brick, and an inner one of brick or concrete block. Andover has few homes from before the 1920s: about one in twenty. Outside walls built after the 1920s are probably cavity walls, and at the survey we check whether yours has an empty cavity.

How Andover homeowners benefit from Cavity Wall Insulation
When we find an empty cavity in your Andover home’s outside walls and fill it, your rooms hold more heat. You get the benefits below when we fill a cavity we have checked at the survey and found suitable.
Warmer rooms with no floor space given up
Beads in the cavity slow the heat escaping through your outside walls, and the insulation sits inside the wall. A lining inside a solid wall takes floor space from the room. Approved Document L, the energy guidance under the Building Regulations, allows the lost floor space only within limits. In nearly a quarter of Andover homes, the detached ones, we fill all four outside walls where there is a cavity. In a semi there are three, and in a mid-terrace the front and back.
Insulated walls that look the same from outside
In brick walls, we drill each hole into a mortar joint and, once the cavity is full, close it with colour-matched mortar. Whatever the finish, we make good every outside surface and leave it as we found it. As long as the outside looks the same afterwards, fitting insulation does not normally need planning permission. The exceptions are listed homes and homes in the Andover Conservation Area, the town’s only one, where you check with the council before we drill.
A filled cavity that still lets rainwater drain away
Rainwater can cross a filled cavity by tracking over a bridge, such as mortar left on a wall tie or rubble at the base. It can also soak into the insulation and pass through it. Because EPS absorbs no water, EPS bead is less prone to soaking than blown mineral wool. Between the beads of Superbead EPS, gaps let any water that enters drain to the ground.
Walls checked inside the cavity before any drilling
Before we drill, our borescope camera shows the cavity and its ties. In pre-1980s walls, ties can rust, which can crack mortar and let damp in. Where an Andover home was built up to the early 1980s, as nearly half were, its cavity ties may be that old. Among the conditions for filling, a cavity should generally be at least 50mm wide, rubble-free and in sound brickwork. Where the wall is solid or the cavity too narrow, consider loft insulation. It is among the easiest, cheapest energy-efficiency improvements, and with care we can fit it in older buildings.
Your semi or terrace insulated without waiting for next door
Every semi and terraced house shares at least one side wall with next door, and Andover’s homes are about a third terraced and a quarter semis. A cavity barrier where your wall meets the neighbour’s keeps the beads on your side. Our team puts in that barrier, or a cavity brush, on each line where your house meets the next. We can then fill your house while the neighbours’ walls stay as they are.
How our Cavity Wall Insulation service works in Andover
Take a look below to find out how our Cavity Wall Insulation service works in Andover,
- 1
Book your free Andover survey
Get in touch and we set up a free, no-obligation survey of your Andover home’s outside walls.
We check the width of the cavity at the survey and look inside for debris or insulation already there.
We then tell you whether Superbead EPS suits your walls. We also say whether the brickwork or the mortar between its bricks, called pointing, needs repair first.
- 2
Receive your fixed price quote
Next, we price the job from the area of outside wall and the access we need, and send you a fixed-price quote.
All materials and labour are in the quote, sealing each drill hole included, with no hidden extras.
If we ever believe your property isn’t suitable, we’ll tell you upfront. We say why, such as a cavity that is too narrow or was filled before.
- 3
Professional Cavity Wall Insulation service provided
The team usually needs 2–4 hours and works from outside the house the whole time.
Our team drills the holes in the mortar joints and injects the beads one section after another. We watch the fill until the cavity is full.
Once the team has cleared its debris, we walk round the filled walls with you. We also tell you about your 10-year guarantee from the IAA, the Installation Assurance Authority.
How much does Cavity Wall Insulation cost in Andover?
For an Andover home, cavity wall insulation in Superbead EPS costs £1,250–£3,500 with Loft Insulation Specialists. We set your price within that range from the area of outside wall and the height the team works at. A two-storey mid-terrace usually costs less than a detached house or one with a third storey. After the survey, we send you a fixed-price quote, and the figure stays as quoted once you accept it.
The Andover suburbs we provide Cavity Wall Insulation services to:
Anna Valley, Charlton, Hurstbourne Tarrant, Picket Twenty, St. Mary Bourne, Upper Clatford
Our services in Andover
Cavity Wall Insulation Andover Nearby
Why Choose us for Cavity Wall Insulation in Andover?
Award-Winning Services
We have been recognised as the 'Best Loft Insulation Installation Firm 2023 – Hampshire' by the Southern Enterprise Awards, an independent awarding body.

Guaranteed energy savings
We guarantee up to 35% lower energy bills by slashing heat loss, backed by our free survey, transparent results and full satisfaction pledge.

Proven Accredited Reliability
Checkatrade and Google reviews from Hampshire locals verify our punctuality, spotless sites and top-quality services - independent proof we deliver every time.

True Local Hampshire Experts
Fast same-week surveys and quotes, as well as tailored solutions for local projects mean quicker installs and better results than out-of-area firms.

40+ years of experience
With over 40 years of experience in insulation and home improvements, our team quickly diagnoses issues, gives better advice, and delivers installations done right the first time.

No-obligation surveys
Our surveys are always free with zero obligation. No high-pressure sales or jargon: just straightforward facts and options, respecting your decision every time.


Frequently asked questions
Take a look at the Frequently Asked Questions regarding our Cavity Wall Insulation services in Andover.
Do the Building Regulations cover filling cavity walls in Andover?
Yes, under the Building Regulations, filling a cavity wall is building work. Either building control, which checks building work, receives notice of it, or an installer registered with a competent person scheme self-certifies it. The Building Regulations list those schemes. On our jobs, the installation is registered and certified under a competent person scheme, which means you do not apply to building control yourself. Under Approved Document L, a listed home or one in a conservation area need not meet the energy standards in full where that would unacceptably alter its look or character. Listed building consent is not covered by that relief, and you apply to the council for it.
How can I tell if my Andover home has cavity walls?
Your home’s brickwork often shows whether it has cavity walls. In a cavity wall, the bricks usually all show their long sides. A solid wall shows the ends of some bricks. You can also measure the wall at a door or window, since cavity walls are probably thicker than solid ones. Because some cavity walls were built to look solid, the pattern is only a sign. Render, common on fronts in the Andover Conservation Area, leaves no brick pattern to see. A rendered wall needs a professional check, and we make it at the survey.
Can a Andover flat or maisonette have cavity wall insulation?
Yes, a flat or maisonette in a block can have cavity wall insulation, but only when the whole block is filled. Getting everyone in the block to agree to the work is the first step.
Which Andover homes have cavity walls that can be filled?
If your home was built from the mid-1940s to the early 1980s, like about a third of Andover’s, it is among the likeliest to have an unfilled cavity. In England, cavity walls far outnumber solid ones in surviving homes of that age, though pre-1990s walls may lack insulation. Of homes from the early 1980s to late 1990s, nearly one in five of the town’s, 1990s ones generally have wall insulation and earlier ones may not. An inter-war home could be solid-walled or cavity-walled, and we check which at the survey. East Anton’s homes, like others from this century, probably have insulated walls. Pre-1920s homes more often have solid walls, and any early, narrow cavity is unsuitable to fill. We look for a cavity at the survey.
How quickly can my Andover walls be surveyed?
We usually come to look at your Andover walls within the week you contact us, because we offer same-week surveys and quotes. Phone 023 9326 7900 or send an enquiry, and we book your free, no-obligation survey. At the visit we check for a cavity, measure its width and look for rubble or insulation already in it. For the rest of our work in the town, see the Andover service area page.
About Andover
Andover
Featured Business LocationLoft Insulation Specialists near Andover
general contractor, manufacturer, service
5 stars (8 reviews)Phone: 023 9326 7900Nearby Suburbs






